From: Mark Booth (markb_at_email.domain.hidden)
Date: 1998-02-09 20:15:36
In message <199802091525.PAA19344_at_elm.ukc.ac.uk>, phw
<P.H.Welch_at_ukc.ac.uk> writes
>I'd like to get occam on the ARM/StrongARM also. Embedded Solutions Ltd.
>are selling their Handel-C targetted at ARM/FPGA or ARM-core-plus-ASICs.
>One selling point is that you program the ARM in C/C++ and the FPGA or ASIC
>in Handel-C, which is a C/C++-like language.
It would be interesting to see if the ARM/FPGA could be combined with
the "OS-Link to Processor Interface" (OSPI) being developed by Brian
O'Neill's team at Nottingham Trent for the SA-110 StrongArm processor.
There is a paper about it at
www.ntu.ac.uk/eee/research/parallel
if you are interested. Apparently the current implementation combines an
SDRAM memory interface, twin DMA controller (one each for TX/RX),
interupt controller, timer (32bits @ 1Mhz), and an OS-link interface,
can be clocked at 30Mhz, and uses 20,000 gates on an ALTERA Flex 10K
series FPGA.
>Actually, Handel-C is just occam1 with curly brackets, lower-case key words
>and a C for-loop!
*8')
Even with transputers being discontinued, it is nice to see some light
at the ends of a few of the side tunnels.
Mark.........
-- Mark Booth
This archive was generated by hypermail 2.1.7 on 2004-10-31 20:03:56 GMT
© Copyright WoTUG
All rights reserved